« previous next »
Pages: [1]

Author Topic: when and why to use 1, 1.5 and 2 stop bits in UART  (Read 13329 times)

titan_amit

  • Member
  • ***
  • Posts: 13
when and why to use 1, 1.5 and 2 stop bits in UART
« on: June 11, 2011, 10:08:17 am »
I read at several places that 1.5 stop bit is prescribed for use only in the case of 5 bit data, 2 bit for longer data length and 1 bit stop can be used for any data length. I wanted to know reason for these recommendations.
Logged

Jan Axelson

  • Administrator
  • Frequent Contributor
  • *****
  • Posts: 3033
    • Lakeview Research
Re: when and why to use 1, 1.5 and 2 stop bits in UART
« Reply #1 on: June 11, 2011, 04:20:34 pm »
My advice is to use one stop bit unless you have a good reason not to. You will likely never encounter a good reason. Compatibility with legacy hardware might be one.

Jan
Logged
Pages: [1]
« previous next »